The TR-1 Top Yoke

In order to set the right ride height and bike geometry, I had to fabricate a new top yoke to raise the front end a bit

Halfway through

Done.

Machines are great, but nothing beat the "hand finish". So, after several hours of smoothing, sanding and buffing, here it is .

Actually this is only the first round of polishing, the detailng will be done later on the build.

 

Other than brace the forks in the new position, the round-ish design let the top yoke "hug" the usual Plan-B-tacho-pod and keep it closer to the rider.

There is still room for some pilot lights and toggle switches...