Another (little) control pannel

The project

...I know, it's very bad, this is why I usually don't make draws

Start making the brass pieces

Unfortunately I've lost some photos of the "making of"... 

anyway the procedure was basically the same of the "manettinodellabenza": file, sandpaper and polish

This is the finished choke lever
(I've made some changes from the initial draw...)

And the idle control knob

New 7075 aluminium engine supports

Fitting Preview

Making the two splitted screws and bolts

Fitting test

Finally all in place

I'll polish it better later

Choke on / Choke off