19/12/11

Another (little) control pannel

The project
...I know, it's very bad, this is why I usually don't make draws



Start making the brass pieces



Unfortunately I've lost some photos of the "making of"... 
anyway the procedure was basically the same of the "manettinodellabenza": file, sandpaper and polish

This is the finished choke lever
(I've made some changes from the initial draw...)


And the idle control knob





New 7075 aluminium engine supports





Fitting Preview




Making the two splitted screws and bolts






Fitting test



Finally all in place


I'll polish it better later





Choke on / Choke off

Choke on-choke off